Posted by Dell (WA) on May 10, 2017 at 02:40:27 from (174.21.215.190):
In Reply to: Talked with Delta Red posted by dopp creek on May 09, 2017 at 18:37:34:
dopp creek........In 1958, I'd just graduated from college witha FCC 1st Class License, Rex Howell (KREX-5) hired me fer his NEW TV transmitter (KREY-10) in Montrose, Colo. This was in the days BEFORE internet, satalite relay. There was a gap inna the mountains at the end of Grand Mesa that I got the TV signal off'n the air and re-broadcast with some local commercials. Fun guessin' when Ch-5 was going to commercial so I could cutt-em OFF and broadcast my own. Hadd about 10-mountain towns that gott my TV signal. Room'n'board $25/week. Jackie made the BEST bread and sammishes. I'd hopp into my 1952 flathead Ford and drive up this really crooked road to the TRANSMITTER. Wore out the rear tires in less than 5000-miles. Complained to my Dad, he said his gov't car tires seldom gott 5000-miles. He was a gov't surveyor fer the Navajo Dam on the San Juan River in New Mexico (USA).
Used to go fly-fishing in the Unpompahgre River. Used to go swimming in HOT-SPRINGS at Ouray.........nostalgic Dell
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
