Posted by JD Seller on January 03, 2017 at 16:03:08 from (208.126.196.24):
I have been reworking a JD 4440 I have had for several years. I found a JD 4450 15 P.S. this fall and bought it. So the JD 4440 I ran on the baler was replaced with the JD 4450. This tractor is a late 1982 model JD 4440. It really did not need much but I like them to be SHARP when I sell them. So I went over it with a fine tooth comb. IF anything looked the least little bit off it was repair/replaced. I did repaint it as the fenders had rust on the insides.
I may regret selling this tractor as I have known it its entire life. I am the 3 owner. The first two lived about 2 miles apart. The biggest thing this tractor ever pulled was an 18 foot disk. I have the 9 bolt duals that were sold with the tractor when the second owner bought it. They have the tires that came on the tractor from the factory. So you can tell it was never on the road much.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Storing Your Tractor - by Staff. If your tractor is going to be stored for any length of time, a few precautionary measures are helpful in preserving various parts, also in avoiding future difficulty. Store tractor under cover. If impossible to place tractor under cover, be sure to cover air stack and exhaust pipe. Drain radiator and engine block. To avoid gum content collections, drain both fuel tanks and carburetor. Leave radiator and fuel caps slightly loose to protect gaskets. Block tractor up to remove weight from tires and to keep tires from contact with moist floor.
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
