Posted by paul on February 18, 2016 at 14:04:19 from (76.77.197.114):
In Reply to: 1000 pto reducer? posted by indianabuckman on February 18, 2016 at 13:28:09:
There are several adapters that can mate a 1000 tractor pto to a 540 implement. If one is careful to run at about 1/2 throttle and if the pto length is right it can work out tho not ideal. Most farm supply stores have them over in the chain, hydraulic, pto, hitch pin section of the store.
For a time some companies (was Hub a popular one?) made an actual gear set that would reduce the pto speeds so you could run at full throttle and have actual 540 output. However they were so expensive they didn't sell enough and I don't think they are still being sold?
Some fertilizer spreaders and such equipment also has that type of gear reducer on them, so folks can pull the spreader with either size tractor and just pick which stub to attach the pto to. That could be handy to have coming off a salvage spreader.....
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor: Conclusion - by Anthony West. In the last piece I mentioned that Nuffield had reached the stage where they had chosen to drop the "Universal" from production. The two new models were given three figure numbers, instead of "three" and "four". Model numbers were introduced to help farmers and dealers instantly recognize the engine size and horsepower of the tractor, the 4/60 had a four cylinder diesel engine which developed 60 bhp at 2,000 rpm. The 3/42 had a 3 cylinder diesel engine which produced 42 bhp at 2,000 rpm. Th
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
