Posted by LOU from Wi. on July 14, 2015 at 18:48:00 from (207.118.214.128):
Coming right down the wire. Son added several more pieces to the puzzle, then it will be painted and ready to go to work. Daughter gets her wood delivered tomorrow,AM, so hopefully the new splitter will get its workout. Been taking a lot of time off due to hot humid weather 80- 90 degree day with rain. I really don't see how my son can keep up with everything, IE splitter, garden, lawn, etc.etc. Figuring when the log splitter is done, it should be in the neighborhood of costing ( a new one) around $2,000.00 to 2500.00, if we had to buy it new. Our cost is below 1/2 that for materials,not counting labor.
The motor came with a frame and a complete manual trans-axle,which we have no use for and will put up for sale. Not sure what lawn mower manufacturer it came from. If I was younger it would be on a go-cart,so I could go check the mail.Oh well. The case that says, better late than never, is better never than late . The guys on here who were contemplating building one, I say do it, they are quite a project,and a worthwhile one at that. The splitter saves a whole lot of problems with aching back and worn out joints. When we get it all finished we will show you the end result. Warmest regards, LOU
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
