Posted by John A on November 29, 2014 at 10:09:49 from (162.251.9.41):
In Reply to: John Deere 168 loader posted by Moline_guy on November 28, 2014 at 19:21:39:
Having put more hrs on a 4630 & 4640 Useing the same JD 168 Loader Than I care to admit to. It will fit. Tx Jim expanded view is Spot on, We ordered our 168 to fit a 4630 initially so it was simply a bolt off, bolt on process to transfer ours to the 4640. So if there are different width #14 I do not know. What I am Dead sure of is You will have to remove your Front Wt Bracket to install the Loader brackets. Most folks will need a ftont wts from time to time.... JD made a Narrow Front wt Bracket to replace # 8! So your loader brackets and "a" front wt brackets can all be in place When needed. It is a Major PIA to have to drop of the loader brackets, just have a wt bracket in place when it is needed. Hope this helps! Later, John A.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor: Conclusion - by Anthony West. In the last piece I mentioned that Nuffield had reached the stage where they had chosen to drop the "Universal" from production. The two new models were given three figure numbers, instead of "three" and "four". Model numbers were introduced to help farmers and dealers instantly recognize the engine size and horsepower of the tractor, the 4/60 had a four cylinder diesel engine which developed 60 bhp at 2,000 rpm. The 3/42 had a 3 cylinder diesel engine which produced 42 bhp at 2,000 rpm. Th
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
