Posted by JD Seller on November 29, 2014 at 06:31:15 from (208.126.198.123):
In Reply to: John Deere 168 loader posted by Moline_guy on November 28, 2014 at 19:21:39:
Well guys all I know from mounting a few hundred loaders is that the JD 4640s used a different bracket than the narrower frame loaders. I never mounted a 148-168 new but have mounted may 265 720, and 740 loaders. They all called for a different bracket for the 4640 then the smaller tractors.
Moline guy measure the distance across the frame rails and then compare it. It is possible that the mast on the newer loaders was different because of the wider fuel tank. The older brackets did mount lower so they MAY fit since they did not extend up over the frame rails much.
IF all else fails you can make it fit with a torch and welder.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor: Conclusion - by Anthony West. In the last piece I mentioned that Nuffield had reached the stage where they had chosen to drop the "Universal" from production. The two new models were given three figure numbers, instead of "three" and "four". Model numbers were introduced to help farmers and dealers instantly recognize the engine size and horsepower of the tractor, the 4/60 had a four cylinder diesel engine which developed 60 bhp at 2,000 rpm. The 3/42 had a 3 cylinder diesel engine which produced 42 bhp at 2,000 rpm. Th
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
