Posted by gwece on October 19, 2014 at 09:21:05 from (184.11.102.178):
Getting ready to install the 3/4 inch 4x6 mats in my stock trailer. One side of the mats has a groove cut in them about every inch or so running the 6 foot direction. The grooves are about a quarter inch wide and about 3/16 inch deep. The other side has a little raised oval shaped dimples on it kind of in a diamond plate pattern. Which side should I put up? Looks like the grooved side would provide more traction, but the grooves would be running crossways of the trailer and seems to me would make it harder to wash out the trailer. Also, my trailer floor is 5' - 11 inches wide. Should I trim the mats to fit that size or just force them in and leave a slight curve on the sides. Someone told me that would make kind of like a curb on each side to make it easier washing the trailer out? Thanks! gwece
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Storing Your Tractor - by Staff. If your tractor is going to be stored for any length of time, a few precautionary measures are helpful in preserving various parts, also in avoiding future difficulty. Store tractor under cover. If impossible to place tractor under cover, be sure to cover air stack and exhaust pipe. Drain radiator and engine block. To avoid gum content collections, drain both fuel tanks and carburetor. Leave radiator and fuel caps slightly loose to protect gaskets. Block tractor up to remove weight from tires and to keep tires from contact with moist floor.
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
