Ihave heavy mats in my stock trailer and I cut them to fit in the trailer. and two sit side by side in it. As i recall they are 3-1/2" x 5". so their are four setsI drilleled holes in one end of them and threaded havy baler twine through the holes and thenthrough a couple of 1/4" wahers and knotted the twine. I use these for handles to pull the mats out. (I"m sure are other ways of doing this but that"s what I elected to do.)
When hauling stock (cows and/or calves), I put about 6 inches of saw dust, shavings, or wood chips from leocal mill down. When I"m done with the haul, I then shovel the manure and chips into the compost pile or the blueberry patch, pull the mats and hose them off and clean the inside of the trailer. The trailer is 16 years old and there is no sign of rot in the treated floors and very little rust or corrosion.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Storing Your Tractor - by Staff. If your tractor is going to be stored for any length of time, a few precautionary measures are helpful in preserving various parts, also in avoiding future difficulty. Store tractor under cover. If impossible to place tractor under cover, be sure to cover air stack and exhaust pipe. Drain radiator and engine block. To avoid gum content collections, drain both fuel tanks and carburetor. Leave radiator and fuel caps slightly loose to protect gaskets. Block tractor up to remove weight from tires and to keep tires from contact with moist floor.
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
