Posted by formerly ny bill on February 20, 2014 at 21:01:27 from (67.251.107.102):
In Reply to: Whats A Good Price? posted by Bryce Frazier on February 20, 2014 at 19:17:47:
that is a great price for the fast hitch. is the drawbar included? even if not, still a great price. fh drawbars can usually be bought for around $100. the only modification you will need to make is to cut a hole in both sides of the tool box, for the crank arm (for lack of a better term). everything else will bolt up. I used a torch to make the holes on the one I had, so it doesn"t need to be drill perfect. you probably need to get measurements from the donor tractor, unless you can get the tool box included. be aware that the serial # plate is riveted to the tool box, if you swap. you already have the valve, which simplifies the plumbing. with a fast hitch, you will need less functioning jacks on equipment, as you can pick the hitch on a trailer off the ground if necessary. the fh disk- IF you can find one, it will likely cost $4-600 if its decent. and, you already found one.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers WD45 (Gas Version) - by Staff. Beginning production in 1953, the WD45 had the same general look as the WD tractor which was produced earlier - but was much more powerful. This was due to the new 4-cylinder "Power Crater" gasoline engine with a 4 x 4-1/2 inch bore and stroke. Some people feel this was one of the most significant tractors offered by Allis-Chalmers in those days. Nothing in its weight or power class could match its performance. In 1954 they began offering the WD45 with the new "Snap-Coupler&quo
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
