Posted by ajdelhomme on November 26, 2013 at 01:28:06 from (184.156.149.195):
I had a problem with the carb on a miller welding machine. It has a techumseh 160. It would spew out raw fuel while it would surge at idle. Every time I took it apart thinking the float would not seat. I would get it to run perfect and put filter back on. The next day I couldn"t get it to start easy or run good. Well after taking it apart TOO many times and lots of prayers, we finally figured it out. There is a vent hole that comes from the bowl to the front of the carb. The gasket that goes between the carb and air filter has a nothch cut out for this vent hole. What happened was the gasket was stuck on the filter housing and I kept putting it back on where it blocked the hole. Lined up the right way and it ran perfect. Hope this helps someone else. God Bless.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
