Posted by doug - iowa on February 17, 2013 at 17:29:30 from (208.126.0.19):
The old pickup seat was getting pretty shot so I thought I"d pick up a used seat at the junk yard. They had one from a roll over that was in real good shape, and so I bought it. After I got it installed, it occurred to me the airbag had deployed in that rolled pickup. And on the used seat I harvested from it are two seat belt sensors. So now I wonder if they have been "tripped". I don"t want to plug them in and set off my airbag! Any way to check them? I"m assuming they are a simple switch that closes when "tripped", and they show no continuity between the two pins now. And neither do the ones in the old seat (there is only two wires to each sensor). I suppose I could swap the sensors just to be sure, but it looks like you have to do quite a bit of work to get them off. Any ideas?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Step by Step Carburetor Overhaul - 1952 Ford 8N - by Don Stewart. The carburetor kit for the TSX-241A/B/C carburetor is being supplied in only one flavor nowadays. It includes a replacement throttle shaft, new butterfly valve screws, fuel inlet filter, new float needle and seat, new float pin and
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
