Posted by Zachary Hoyt on November 06, 2012 at 14:11:22 from (74.47.61.129):
I have never used a flat belt before, so I am not sure if I have this set up right. The belt has two problem areas, I could cut about 3 feet out of the belt and if there is a way to re-join the ends I would be in business, or I can look for a better belt. The belt moves from edge to edge of the pulley on the tractor when running with no load, I am not sure if that is because of the damaged belt or for some other reason. When I push a piece of wood of any size into the saw and it slows down the belt tends to jump off the tractor pulley. Small pieces seem to cut fine since the blade does not slow, or at least not as much. I am guessing that if I sharpen the saw blade I will have less trouble with this. I am not sure if I have the tension right on the belt, or if my chain hung on the axle is enough to ground the tractor and dissipate static electricity. I have also heard of using a crowbar leaned against the tractor. Any advice will be much appreciated, I have no experience with flat belt equipment. Zach
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
