Posted by SweetFeet on September 28, 2012 at 05:50:47 from (70.35.103.249):
In Reply to: OT Computer Question posted by 60 acre hillside on September 28, 2012 at 05:20:08:
60 acre hillside,
On your menu bar at upper left...
Try clicking on "view" - then a drop down menu appears... try choosing zoom and adjusting to a smaller percentage (or at the bottom where it says Custom, you can enter any size you wish...about 115-120 percent size will usually still all fit on my screen).
Or under "View" try clicking "Text Size" on the drop down menu and adjusting that to a smaller ammount (it ranges from Largest on down to Smallest).
Or go into your Control Panel...over on right side at top there is "View by" with a down arrow and you can select: Category, Large or Small.
If nothing works, I'd go into control panel and select a Restore Point of a date BEFORE your friend did stuff with your computer. Then it will reset everything to the way it was (though if any software downloads were done by your friend, they will be lost).
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.