Posted by LorenC on April 28, 2012 at 19:55:11 from (184.100.21.35):
Part one is the bar on the Mf65 is lower than I'd like, and the gate it's meant to swing in has been repaired with 1/2" vertical clearance. I'd like to weld in maybe a 3" wide flat bar underneath it to get that height. Any reason mild steel won't do that job well? Second part is putting a bar from the straight, upper, front section of the drawbar, to straight out above the drop section. Thinking welding it around the forward section with a wrap around the vertical area of the drop so as to not weld or drill to/on the drawbar itself. I assume that drawbar is heat treated, right? What do you guys think?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Operator Safety - Loader & Backhoe Operation - by Staff. Loader Operation Do not transport anyone in the loader bucket. Always carry the loader bucket low for maximum stability and visibility, whether the bucket is loaded or empty. Always use the recommended amount of counterweihting to ensure good stability. Be careful when handling large objects such as round bales, logs,
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
