Posted by Mike in Mn. on March 12, 2012 at 09:18:47 from (74.46.184.96):
I have a 4L60E hanging on the stand, 94 chev 4x4. It has 230,000 miles and works perfect except it does not have third gear or overdrive. I have done dozens of 350 and 400's but this is my first one of these. I have the tools for the older ones. Couple of questions. Are there any special tools that I absolutely have to have that I can't build?? Can I pull the pump and guts without pulling the valve body and the servos etc.?? I assume there is a clutch bad, but there wasn't too much crap in the pan. Or should I do a complete dis-assembly and a complete OH.?? I mean a master kit and a rebuilt converter. All advice is appreciated, thanks!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Recollections of a John Deere GP - by Charlie Cook. I grew up on my dad's 280 acre general farm in Western Michigan. Dad's only tractor when I was very young was the old GP. My first recollection of this tractor was when dad allowed my brother and myself to ride on the tractor with him driving. One of us would sit on the left fender (away from the clutch) and other would sit on the gas tank and hold onto the crankcase breather pipe.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
