Good idea about making a part that drops in the stack pockets with a heavy beam with a ball attached. I have two square pieces of tube in each pocket now. Have a piece of square tube across them and a hand winch mounted at cab height. I use it to pull my 12 foot boat up on the bed of the truck. Have a receiver hitch on the back with a T shaped piece in the receiver hitch. Have rollers on the T part and the aluminum boat comes right up out of the lake or ground and into the truck bed. Think I'll do what you suggest and mount the electric winch onto a beam going across the pieces in the stack pockets. What I built ins't strong enough to support the electric winch at cab height. It would be ok for the boat but need to put it lower for pulling things I collect like steel plows into the bed. Sending a picture of a snatch block sold at Pacific Industrial Supply.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Buying your first tractor: The People You Buy From - by Chris Pratt. If you are a first-time buyer, chances are that you are likely to take the word of the seller on things. This is where the problems start... You have reviewed your implement needs and determined the size of machine that will fit the bill and even made a list of the most desirable models. You checked on the availability of a 3-point hitch for the machines on the list and advertised in your local classified paper with so
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
