Posted by Fixerupper on December 16, 2011 at 18:35:07 from (199.120.105.202):
Or service pit for doing oil changes and service work on a truck. I'm remodeling part of the cattle shed so it will eventually be a service shop mainly for a truck but the tire changer will be in there too, and who knows whatever else. Anyway, the shop will be 40 feet long and the semi tractor is close to 30. Some of the floor is still dirt so I'll be pouring cement next summer so now's the time to come up with plans for digging in a pit for the truck to straddle. How deep should it be? My son is 6'3 I'm 6'2 so we're thinking 5'6" depth. Neither one of us can work stooped over and we figure if we need to reach up into the frame far we can use a low step stool. How wide should it be?
We were brainstorming tonight and I came up with an idea of having a track recessed in the sidewalls for a cart to run on to hold the oil drain pan, tools, or whatever. The rails should be heavy enough to hold a truck transmission, so I'm thinking 2000 lb. Air and electricity will be available in the pit. I'd like to have lights shining up from below but I can see problems with that idea unless you guys have a good suggestion.
How long is the average pit for truck service? This is not a rush job and it will not turn into one. If I do this myself I can add a lot of bells and whistles economically. The building is located on gravelly, rocky soil, moderately high profile and my assumption is there will be no problem with ground water.
What should I NOT do? Lots of questions but I'm going to run this through my mind all winter so I can hopefully have my act together next spring or summer when I can hopefully get it done. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
