I hunt, almost every day during pheasant season. I enjoy the walk and being outdoors. I do not own any land. I hunt DNR land and the old farm place I was raised at, plus friends that are farmers and I work on their equipment. Many, many times I see birds on land I do not have permission to hunt on. I just enjoy the sight of the birds then. Far be it for me to walk onto a grass land, slough or field and get my hind end chewed on. Most people know me and I am sure they would just say, oh it's you Pete but some would not. Like I said before, I used to have a NO HUNTING SIGN in my tool box, that brought a few strange looks. Well, it was MY property. If they asked I always said, sure, use a tool. Once in a great while I would ask if they cared if I hunted on their land. I try to give out good sound advice on this forum, no charge, because I enjoy and appreciate some one can make use of any knowledge I have acquired over the years. I have seen some hunters who do not respect other peoples property, but in all honesty, the biggest offenders around here are actually farmers them selves who drive all over heck in the fields with their pickups, straffing the sloughs etc when they are on their deer or coyote hunts. Makes a guy kind of leary out there pheasant hunting. I walk from the roads to my destination and at 75 think some of them could use a little extra walking themselves. This kind of crap on here upsets me.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.