Posted by dave2 on December 01, 2011 at 16:43:47 from (139.139.35.70):
Been nursing one since last week in September and have my whole leg screwed up from favoring it. Went to the doctor today... Told him what I thought, he squeezed around to make sure I wasn't lieing, took an xray to verify (a blind man could see it).... And asked if I wanted it fixed or wanted treatment that insurance will pay for. Said I wanted it gone (my insurance will pay anyway). Treatment is like an air hammer that he ran all over the heel concentrating on where it hurt the most for about 16 hours (5 minutes or so)..... Kinda like beating your head against the wall.... Hurts like heck but feels darn good when you stop...... Said that the heel spur was an infected area and the hammering would cause blood flow which would flush the infection away. Prescribed antibiotics to take twice a day for 10 days to get rid of the infection done imprints of my feet for ordering insoles, and said I need two more hammerings a week apart and will have no more problems.... Feels better already.... Wife had a real bad case of tennis elbow that is completely gone after 3 of the same treatments.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.