Posted by LJD on November 17, 2011 at 09:31:31 from (67.142.130.22):
I'm hoping to find someone, somewhere that has one of these engines sitting around. In a tractor or out. I need some measurements.
The "B" in these IH engines stands for "British." Use in many farm and industrial tractors. B-250, B-275, B-414, 424, 444, 2444, 2424, 354, 364, 384, industrial 3414, 3444, TD-5 crawler, etc.
I have a 3414 backhoe wheel loader and it's parked 800 miles for home. I need the specs on the hydraulic pump drive where it bolts to the crank pulley. It's held on by four bolts and I need to know their spacing. I want to build a new one and have it ready to use next time I travel to where the hoe is.
Note that the ealier farm tractors e.g. the B-250 and B-275 do not have the crank pulleys drilled for the pump drive, like the later engines do.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.