Ford Tractors Discussion Board |
Re: 2000 3-cyl torque specs
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Charles (in GA) on August 21, 2004 at 21:40:39 from (24.216.255.186):
In Reply to: 2000 3-cyl torque specs posted by John A (TX) on August 21, 2004 at 18:53:33:
First off, you really do need a manual. I don't see how you can do it without, too many numbers, ring gaps, manifold torques, color finish and orientation of the piston rings, diesel or gas? etc... Well, I cannot show you the cylinder head tighening sequence, but its a basic start at the middle, back and forth across the engine, and work toward the ends. Start on the exhaust side in the middle. Cylinder head torque is three step, 80/90/100 ft/lb. Rod nuts, 60-65 ft/lbs Main bearing caps, 115-125 ft/lbs Oil pump, 23-28 ft/lbs. Piston notch goes to front and rod and cap numbers go to the right. If your friend wants a quality job, order a manual and wait on it. Charles
Follow Ups:
Home
| Forums
Today's Featured Article -
Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|