|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: 706 Trans Inspection Plate?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by SDman on August 11, 2000 at 10:56:26 from (208.248.137.139):
In Reply to: Re: Re: 706 Trans Inspection Plate? posted by Red Rookie on August 10, 2000 at 11:20:26:
Red Rookie, I'm sorry but I don't follow where you are describing. On the engine side, behind the flywheel, will be a retainer that the rear main fits in(its tough to see as the flywheel pretty much covers it up). On the trans. side, behind the throwout bearing assembly, will be a 4-6" circular cover that covers the PTO gear; around that will be a 10-12" circular cover that covers the front part of the TA, if equipped, or the countershaft drive gear if there is no TA. There are no gaskets here, just O-rings & lip seals. Also, there is a smaller 4-bolt round cover at the bottom of the trans. housing that covers the transmission countershaft. It is also an O-ring. Hope this helps.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
