|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: 706 Trans Inspection Plate?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Rookie on August 11, 2000 at 12:17:09 from (208.234.125.98):
In Reply to: Re: Re: Re: 706 Trans Inspection Plate? posted by SDman on August 11, 2000 at 10:56:26:
Thanks SDman!! Last night I pulled the part off in question and called Case with the number. You nailed it! It was the transmission countershaft cover. Someone had taken it off and when they replaced it they left off the shim and gaskets, using only RTV sealant. When they replaced the cover and torqued it they cracked that cover and it finally snapped in two. With any luck the part will be in tomorrow and I will be suffering through another day of 100 degree Texas weather in the field. Thanks again for your patience and help. You keep us shadetrees honest.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Preventing Tractor Theft - by Staff. The discussion started with the following message: I have a JD A without key start or any locking device. Is there a best way to secure it so the chances of it being stolen are reduced? Following are some of the answers that were received: Take the rotor out of the distributor and hide after each use. The would-be thieves at least couldn't just get on and drive away.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
