|
Farmall & IHC Tractors Discussion Board |
Re: Re: 706 Trans Inspection Plate?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Rookie on August 10, 2000 at 11:20:26 from (208.234.125.98):
In Reply to: Re: 706 Trans Inspection Plate? posted by SDman on August 10, 2000 at 11:02:43:
Thanks SDman! Also sitting in there was what looked like a round piece of broken casting. I noticed about ten inches up from the access plate a square plate mounted against the clutch wall which had a gasket on it but a round hole was puched through it. Do you thing that is where the fluid is coming from? The fluid that was leaking from the bottom access plate was definately trans fluid. I have been using oil but I have an oil cooler leak I want to fix before further diagnosing that problem. Thanks for your help...RR
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Engine Basics: Spark Plug Cleaning - by Staff. Cleaning procedures: Brush or blow dirt from around the spark plug base. Remove the plug with a correctly fitted wrench. Examine the porcelain insulator and points. If the insulator appears to be melted or blistered, cracked or broken, and the points seem unduly burned it is evident that the plug is operating too hot and it should be replaced with a colder plug. If the plug is fouled excessively with carbon it apparently is operating too cold and it should be replac
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
