Posted by Mike CA on November 13, 2007 at 19:05:04 from (214.1.211.251):
I took two small boxes of H parts in to the Auto Hobby Shop on my base so I could steam clean and sand blast them. The "enviromental safety" office came through for an inspection not too long ago and didn't like the set up for the sand blaster because some sand escaped towards a drain. So they shut it down. No more sand blasting. They shut down the painting booth a couple years ago I'm told. The steam cleaner is just a hot pressure washer, but doesn't get steamy.
The saving grace in my adventure tonight is that they have a pressurized parts cleaning tank. The guy let me put all the stuff in there to get sprayed all night. I'll pick it up tomorrow. I don't hold out much hope for the inside of the radiator pipe, which was scaled with rust. But we'll see what happens. The oil pan. breather cup, breather, and hydraulic access cover desperately needed cleaned off, so they, at least, will get what they need.
I'm just bummed I can't clean the stuff they way it needs to be done.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
