Farmall & IHC Tractors Discussion Board |
Re: Charging a battery backwards
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Andy Martin on July 06, 2007 at 16:13:19 from (216.150.108.117):
In Reply to: Re: Charging a battery backwards posted by Lanse on July 06, 2007 at 14:49:10:
And in my experience, you don't have much experience. I have inadvertently reversed charged a battery, at least twice in the last 40 years and have never ruined the cables or starter. One of the batteries was probably no good anyway but the other one charged back up just fine and ran for a few years. The problem in guessing your posts on this board is that there are folks here who do have experience and are not shy at pointing out your inexperience if you are being obnoxious about it. Your professional advice that the plates could be "messed up" have no technical basis. By the same token, those with experience try not to embarrass those without experience because if someone makes fun of you for asking what they think is a stupid question, then you quit asking and may damage a tractor or get hurt. The only stupid question is the one that is not asked, and the only one who mkes no mistakes is the one who does nothing. I am a registered professional mechanical engineer, I really farm with letter series Farmalls and I have hooked batteries up backwards (in a hurry, post on the opposite side from normal, and several M's with positive and negative ground). In fact I have made lots of mistakes farming and engineering but it is persistence that gets the job done, not perfection.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|