|
Farmall & IHC Tractors Discussion Board |
Re: ...A SILLY QUESTION!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Allan In NE on November 03, 2006 at 16:07:07 from (148.78.243.24):
In Reply to: Re: ...A SILLY QUESTION! posted by Nat 2 on November 03, 2006 at 09:42:30:
About this lineage thing; with all due respect, I don't think ya have it quite right. The 686/666/656 tractors are basically nothing more than an updated version of the 560, which in turn was an updated version of the 400/450 and going back to the SMs and the M. The 300 is and updated SH, originally from the H and it later led to the 350s then the 460. Whole lot smaller tractor. A bit later and while all this was going on, the added 706 style line led right up the pack thru the 756/856/1256 and the 766/966/1066/1466 tractors. They are all grouped into their own distinct family designated by size. Allan
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
