|
Farmall & IHC Tractors Discussion Board |
Re: F-20 Governor/Throttle
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tony (A2, MI) on August 04, 2006 at 07:54:20 from (64.199.1.202):
In Reply to: Re: F-20 Governor/Throttle posted by Nebraska Cowman on August 04, 2006 at 04:54:02:
Yes, it is the Narrow. I have had the mechanism that goes between the governor and the carb off, and I do have the "fingers" in the right place. When I adjust the throttle control, the butterfly in the carb rotates between fully closed and fully open (which sems right). It must not take being open very far to make her speed up. How would I check the machanisms inside the governor itself? This is the tractor that hoad not run in over 50 years until a month ago, so it is possible something could be gummed up in there. Could you let me know what you mean by "main spring on the arm" so I can look for that? Thanks as always!
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Engine Basics: Spark Plug Cleaning - by Staff. Cleaning procedures: Brush or blow dirt from around the spark plug base. Remove the plug with a correctly fitted wrench. Examine the porcelain insulator and points. If the insulator appears to be melted or blistered, cracked or broken, and the points seem unduly burned it is evident that the plug is operating too hot and it should be replaced with a colder plug. If the plug is fouled excessively with carbon it apparently is operating too cold and it should be replac
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|