|
Farmall & IHC Tractors Discussion Board |
My old model M won't start
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dummy Bob on April 16, 2006 at 15:21:43 from (24.155.164.200):
Knowing a little less than nothing about tractors,I need help. My M will not quite start. Sounds as if she is going to but will not quite fire up. Gas runs out of the bottom of the carg when choked. Carb has had a new kit installed, works fine on another tractor,but still floods and won't start on mine.This M has been converted to 12v. Bought it that way.It still has the mag on it, but runs off the alternator.Now for my dumb question. Where are the points? took off the distibuter cap and rotor,took off the plate, little gears inside, no points or condenser Where are they?
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|