Farmall & IHC Tractors Discussion Board |
oil pressure in an A
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by fenton on October 31, 2005 at 07:04:59 from (128.253.9.82):
Installed a new oil pressure guage in the Super A and I have to say it's quite a busy needle. When I start her up cold it jumps up fast to the center, a good thing I guess, then after warm up it goes back down to about a quarter (not sure how many pounds that is) but lets say two notches on the guage. When reved a bit it raises accordingly to about a third or a notch or two below half way. Now, I'm running 10/30 in her, so I'm thinking maybe it has to do with the oil thinning as it heats up?? I know these old fours don't put out much pressure, but is this normal.....?
Follow Ups:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|