|
Farmall & IHC Tractors Discussion Board |
Re: F20 governor about has me whipped.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by James Williams on July 24, 2005 at 13:50:17 from (170.215.132.77):
In Reply to: F20 governor about has me whipped. posted by The other Bob in Texas on July 24, 2005 at 08:13:46:
Bob,when i saw your e-mail I couldnt wait to read it.Just experenced the same thing last night,a friend came over and we fixed in about 30 minutes.your weights are stuck.you need to take the back off the govenor{closes to the radiator}you will se a ball between the 2 weights,this ball is supose to slide back and forth and allow the weights to move up and down.mine was stucked very tight,we sprayed blaster on the complete govenor and took a bar and light hammer and drove the ball back and forth ,by doing this several times we were able to move it very easily.we reinstalled the plate and it worked perfect 304-725-1037
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
