|
Farmall & IHC Tractors Discussion Board |
560 Hydraulics Broke??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Robert Searcy on March 14, 2005 at 13:53:52 from (208.24.179.208):
My dad purchased a 560 Diesel, its a late model - 63 I believe. When he puts the loader down it will not pick up the front end of the tractor. It is an F11 Farmhand. Also when he puts his blade down, it comes within about an inch or two of the ground and will not touch unless he goes across a ditch or something. There is about 3 inches of stroke still showing on the two point cylinder. We had pulled all the pins out and stuff for when you are plowing, replaced them. Is there some adjustment somewhere on the thing or are the 560 hydraulics just not capable of this. It will lift anything up with that loader and if you put a chunk of wood or something under that blade it will about pick up the tractor, just no down pressure. Our Farmall 400 had a rear blade, same two point and Koyker loader and it would pick the entire tractor up off the ground. Dad is not very happy with his 560 right now. Any advice?? Thanks, Robert
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Ford 600 Series - by Staff. The Ford 600 Series tractors bean production in 1954, and continued until 1957. Quite similar to the Ford NAA (Golden Jubilee) in design, it used the same 132 cubic inch Red Tiger engine with 31 horsepower. Several different models were made in the 600 Series, and these numbers were used to denote whether they used a particular transmission, hydraulic system, or PTO. The result was five different model numbers: 620, 630, 640, 650 and 660. These break down as follows:
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|