Re: 560 Hydraulics Broke??

Posted by Robert Searcy on March 14, 2005 at 18:58:36 from (68.25.180.6):

In Reply to: Re: 560 Hydraulics Broke?? posted by Allan in NE on March 14, 2005 at 15:27:04:

Well, it doesn"t appear that it has a stop as the entire shaft is bare up to the point where the yoke pins to the brace on the tractor. I presume that if there was a stop it would be on the cylinder shaft?

The bottom of the cylinder is pinned to the bracket on the bottom of the 2 point hitch towards the ground.

I am not familiar with the draft Heavy position but I presume you are talking about the handle on the side that has an oblong loop on the top to grab with about 4 positions that it will latch in as you pull it upward toward the seat.

It doesnt seem to make any difference with that lever all the way up or all the way down.

I like the other 2 point we had on our 400 much better, it had a separate cylinder on it that was like a leveling cylinder that ran fore to aft under the belly on the drivers side.

Follow Ups:

Post a Followup Name: E-Mail: Hide: Yes No Hiding your address protects you from spam generators but allows you to receive email response notifications. Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]