|
Farmall & IHC Tractors Discussion Board |
No fuel to cylinders on M
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MikeInIA on November 12, 2004 at 14:32:16 from (216.190.124.50):
I am trying to get a M started after sitting for two years and there is no gas getting up into the cylinders. I rebuildt the carberator and checked the following: fuel coming out of line has good flow, new gas, throttle is not stuck, tune up parts replaced, valves and rods all moving properly, distributor is turning. Choke seem to be working also. continuing syptoms: I am getting alot of flow back leaking from the carb., tried ether in the manifold whole, got it to pop a time or two but still no fuel... don;t even smell fuel on ignition plugs. Thank you in advance for any suggestions on what could be the problem.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Engine Basics: Spark Plug Cleaning - by Staff. Cleaning procedures: Brush or blow dirt from around the spark plug base. Remove the plug with a correctly fitted wrench. Examine the porcelain insulator and points. If the insulator appears to be melted or blistered, cracked or broken, and the points seem unduly burned it is evident that the plug is operating too hot and it should be replaced with a colder plug. If the plug is fouled excessively with carbon it apparently is operating too cold and it should be replac
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
