Farmall & IHC Tractors Discussion Board |
Re: 650D/WD9/MD etc. injector pump Troubles...HELP
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ja0091 on August 19, 2004 at 20:19:39 from (65.169.88.151):
In Reply to: 650D/WD9/MD etc. injector pump Troubles...HELP! posted by Ron in Nebr on August 19, 2004 at 18:03:40:
your 650 should have a type B pump.(no scavenger pump). it has a big IH cast on the side. a gear pump is positive displacement, so if it is turning, it should be pumping, unless the internal clearance is too great. remove the rear cover, and see if the gears have worn into the cover. the pump shaft gear is driven by a woodruff key. check for a sheared key. the pump pressure should be 58-66 lbs. at full engine speed. maybe this will help! ja0091
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|