Farmall & IHC Tractors Discussion Board |
Re: 650D/WD9/MD etc. injector pump Troubles...HELP
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ron in Nebr on August 19, 2004 at 22:39:44 from (65.172.143.235):
In Reply to: Re: 650D/WD9/MD etc. injector pump Troubles...HELP posted by ja0091 on August 19, 2004 at 20:19:39:
Thanks for the reply. The manual I have doesn"t show any difference between the pumps as far as one not having a scavenge pump, so your response was helpful! The rear cover on the primary pump looks good where the gears go- no scoring that I can see. The gears don"t look too bad either. I took the primary pump off and it appears all the keys and pins are in place. There"s not much end clearance on the shaft or gears with the rear cover in place, so that should be ok too. I didn"t look inside the main pump to see what things looked like in there when I had the primary off....guess that"s my next step. Needs new gaskets and a shaft seal on the primary anyway. Thanks again!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|