|
Farmall & IHC Tractors Discussion Board |
end play
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by SGT K on January 16, 2004 at 10:16:43 from (65.120.161.32):
How much end play should my brake shafts have on my H? I took the brake cover and brake band off, then the dum. The splined shaft has at least a 1/16 of an inch end play. That seems like a lot. Just to check I took off the other side, all most as much. Also, has anyone replaced the seal on this shaft without tearing into the transmission? The seal is about 3/4 of an inch thick and I bet it doesn't come out without a fight. Thanks in advance, I'm alittle scared to start pry'n, hammer'in and pulling. I have had a habit of tearing up more than I fix. ;]
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
