Farmall & IHC Tractors Discussion Board |
'H', Differential Seal, and Drive Gear Questions.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Fred KS on May 13, 2003 at 16:29:20 from (64.39.205.106):
Pulled my brake cover and found the shaft oil seal leaking. Removed the seal and found that my roller bearing was about to start spitting out ball bearings. Decided to go ahead and replace both differential shaft ball bearings on both sides, which brings me to these two questions. Since I'm going to pull the bearing cages, would it be easier to remove the oil seal once the cage was out? I'm thinking I could drive the seal out once the cage was removed. Also, is the bolt holding the right hand drive gear a right or left hand thread? I know the bolt on the left drive gear is right hand thread, but the parts catalog shows two part numbers for the bolt with no referrence why. Thanks, Fred KS
Follow Ups:
Home
| Forums
Today's Featured Article -
What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|