|
Farmall & IHC Tractors Discussion Board |
Re: Re: C axle housing/transmission leak
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DHuth2 on August 29, 2002 at 21:15:07 from (198.81.27.16):
In Reply to: Re: C axle housing/transmission leak posted by Haas on August 29, 2002 at 14:20:14:
I recall that the inner seal is pressed into axle housing outboard of the inner axle bearing.Not sure you have enough clearance to slide axle away from the case...bull gear is right there.I would recommend removing bull gear and remove axle and housing.Clean old gasket and if no gasket is available, I use the liquid Gasket maker....Cat makes a good one....I would invest the time into new seal also while your there.....bearing is not bad investment either....I just don't like doing it twice....
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
65 Massey FERGUSON DIESEL
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
