|
Farmall & IHC Tractors Discussion Board |
504 farmall steering
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brian Stewart on April 26, 2002 at 08:15:28 from (204.100.160.134):
I have a 504 farmall wide front tractor that my dad bought new in 1965(I think). The tractor steers hard. I have cleaned the filter and need to get a new one. I have checked the level in the trans by taking out the plug by the step to get on the tractor. i see there are lines that run up to the valve behind the wheel. Can somebody explain to me how it works and how does the front end tie into the steering valve ect.. The shaft runs to the front end and my expierence stops there. I have thought about starting over and putting a power steering pump on the motor and a assist on the front end. Do I need to do this. Please help! Thanks Brian.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Best Tractor? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew quite a bit of response. We see the question of "Which tractor is best for me?" asked quite often. We thought you might find the responses interesting. As always, the names of the people participating in the discussion have been left out - we did not request their permission to reprint their names in this article. However you can find this discussion in it's entirety in the Tractor Talk archives.
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|