|
Farmall & IHC Tractors Discussion Board |
Re: Farmall H steering loose - will it matter with wide front?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on April 21, 2002 at 07:37:24 from (66.66.72.246):
In Reply to: Farmall H steering loose - will it matter with wide front? posted by Steven@nd on April 21, 2002 at 07:19:05:
Steven - My experience has been WF front wheels will tend to "flop" at speed with a steering loose pivot shaft, same as a NF. While you've got the tractor disassembled, check to see if there is ANY lateral play in the pivot shaft - especially at the upper end. Remove the steering pot cover and see if you can move the sector gear horizontally. If you find any play at all, now is the time to replace the pivot shaft bushings. The bushings are relatively inexpensive (Bermuda Ken's price was under $40 for the 2 bushings + the seal if I recall), and not terribly difficult to install. ...Bob M PS - Nice photo!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
