|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: C front transmission seal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on April 10, 2001 at 17:01:33 from (129.37.117.238):
In Reply to: Re: Re: C front transmission seal posted by Dave T on April 10, 2001 at 12:17:11:
Don't think you would have to take the tranny cover off. Once you get the tractor split at the four bolts just in front of the transmission, take off the shaft coupling piece and then the seal holder,drive the old seal out and press in a new one. Anyhow that's the way it looks to me. I think you could tilt front of the tranny up and not have to drain it. My problem also started after changing the oil in the tranny. It was there before, but got much worse after. The tranny had this real thick stuff in it. Looked like half grease. It's not so bad that I can't put it off. Probably won't do anything until this fall.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Horsepower Defined - by Staff. Indicated Horsepower This represents the power developed in the enine cylinder as obtained from the pressure in the cylinders. This is pressure obtained from an indicator which shows cylinder pressures. Indicated horsepower does not represent the actual useful power delivered by the engine. Brake Horsepower This is the actual horse power delivered by the engine to the shaft. It is equal to the "indicated horsepower" less the friction of the engine. It is useful hor
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
