|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: C front transmission seal
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by haas on April 10, 2001 at 19:12:11 from (129.37.117.16):
In Reply to: Re: Re: Re: Re: C front transmission seal posted by Dave T on April 10, 2001 at 18:33:21:
The lower shaft is the transmission counter shaft. It has the 1st through 4th gears on it. It has a cap and a gasket over the end of it. Per the Parts Catalog, there is not a seal, because the shaft does not protrude past the cap. Of course the gasket under the cap could be leaking. I think if the Trans is full up to the level plug, that the level is up as high as the transmission input shaft. I'll look at that tomorrow. Could be oil comes up there when you are running, gets into the torque tube which has a low spot and then runs out gradually.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Horsepower Defined - by Staff. Indicated Horsepower This represents the power developed in the enine cylinder as obtained from the pressure in the cylinders. This is pressure obtained from an indicator which shows cylinder pressures. Indicated horsepower does not represent the actual useful power delivered by the engine. Brake Horsepower This is the actual horse power delivered by the engine to the shaft. It is equal to the "indicated horsepower" less the friction of the engine. It is useful hor
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|