Re: Anyone have PS on an H/SH?
[Show Entire Topic]
[Show Entire Topic]
[Return to Forum]
[Log in to Reply]
Thanks for the advice and the pictures. I got my PS motor in this week and a prioity flow diverter from Northern Tool(Hydraulics) but the diverter valve has no instructions, so I emailed Prince (who made the valve) as well as Northern to try to find out which port is the controlled flow vs which is the excess so I don't get them reversed. I hope to install it this weekend on my SM. Then I will take measurements and see if it's feasable on the SH. If it's too tight, the idea of putting it over the fuel tank is probably a good one, if I can figure out how to make up the brackets.
BTW - I did look at both tractors yesterday with the hoods off and the SH would definately need a different bracket than the SM to mount the PS unit to the gage panel.
Today's Featured Article -
Storing Your Tractor - by Staff. If your tractor is going to be stored for any length of time, a few precautionary measures are helpful in preserving various parts, also in avoiding future difficulty. Store tractor under cover. If impossible to place tractor under cover, be sure to cover air stack and exhaust pipe. Drain radiator and engine block. To avoid gum content collections, drain both fuel tanks and carburetor. Leave radiator and fuel caps slightly loose to protect gaskets. Block tractor up to remove weight from tires and to keep tires from contact with moist floor.
... [Read Article]
JENSEN miniature pump jack. 13W. Operating smoothly. 5 weights.
| Copyright © 1997-2021 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy