| |
Re: draw bar
[Show Entire Topic]
Author |
|
JMS/MN
09-30-2002 08:32:10
|
Drawbar dimensions on the WD with pin hitch and WD45 with Snap-Coupler are (about) the same- hard to measure exactly. Lower piece (front one) is 35 inches, upper piece (rear one) is 25 inches, bolted together they total 44 inches. Two other holes allow for shortening by 4 1/2 inches or 5 3/4 inches. 44 inch length puts the drawbar pin at 15 inches behind the pto shaft. Recommended by Operator's manual that shorter lengths be used for heavy tillage, longer length for pto work. For all practical purposes, no one ever changes them, just leave it set for pto. Some engineer had too much time on his hands.
|
|
| [Show Entire Topic]
[Options]
[Printer Friendly]
[Posting Help]
[Return to Forum]
[Log in to Reply]
Home
| Forums
Today's Featured Article -
The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Bumper - Ford Jubilee, Naa, 8N
[More Ads]
Copyright © 1997-2022 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|