Posted by rrlund on October 28, 2012 at 14:58:41 from (207.241.137.116):
In Reply to: Don't know what to do posted by Icequeen029 on October 28, 2012 at 12:43:59:
I ran my first round baler back in 79 with a 730 Diesel. The 70 should be plumbed about the same way. This worked for me as per dealer mechanic instructions at the time. There's two steel hydraulic lines on the flywheel side of the tractor going from the pump to the powertrol. The small one is the high pressure line. I took that line off,cut a short length of it out with a pipe cutter. I threaded both ends with a half inch pipe die. I screwed a half inch pipe coupler on each pipe,then brazed them on because the pipe wall is so thin that you won't have a lot of material left there after you thread it. I hooked a half inch hydraulic hose to each end,ran it in to and out of a single spool two way open center valve with the oil flowing in the direction that it flows from the pump to the powertrol. I made a nice bracket to bolt it to the left side of the cast cowl above the left headlight. Then I ran a pair of hoses off the valve to the back of the tractor with a pair of couplers in a breakaway clamp. I ran the tailgate of the baler off that valve and the twine arm off the regular tractor remote valve. Worked like a dream. The oil flows through that steel line all the time anyway and doesn't care if it's going through an open center valve along the way.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.