That's the problem with your setup. I'm not judging, just saying, we all cut corners, and in haste, oops we forget something.
You _can_ forget to actually do it.
The electrical types are working on the grounding deal, I'll leave that explination to them, here's my silly version:
When water comes into your house, it comes from the same pipe, some goes tthrough the water heater & then there are 2 pipes to almost all of your sinks, right? One is hot water & one is cold water, and you can't just join the pipes together any old way - you need to keep the hot & cold pipes seperate, or else you will get tepid water or no water, not hot and cold water, & it won't be right. You'll have water, but it won't be right.
Correct?
With the ground and the neutral, they do connect one time in your main box, but any other place they have 2 very different jobs to do. A person needs to keep them seperated, not mixed and matched.
It's just like the water system - it's easy to get water out of the faucet by just plumbing the pipes together anyplace/ any pipe, but to get the right water out of the right pipe, you need to follow the 2 pipe path & keep them seperate.
The nuetral & the ground are like that too - it's not right to mix them up, even tho you get electricity out of the socket.
If you mess up the water system, you might get wet, or too cold or too hot or no water at all. Bummer, but no big deal.
If you mess up that grounding circut, someone could possibly get killed. Doesn't always show up in the first 25 years, but - the possibility is always there.
That's the non-electrician version of the difference between neutral & ground. ;) Probably doesn't help much. But it is important.
The ground circut is hopefully never used, but it needs to run from every device back to that one common bond in one box back at the begining of your wiring. If it has more than one path or gets crossed with the nuetral wire, it no longer can do it's job safely, and then if it is needed, it will harm more than it helps. No noe will know it's wrong (because it's not obvious - the wiring will likely work & provide electricity no matter how you wire it up) until the wrong set of things comes up, & zap.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
