Tractor Talk Discussion Board |
Re: Installing Piston Sleeves
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Greasy John (Or) on December 02, 2003 at 05:54:53 from (208.35.181.65):
In Reply to: Installing Piston Sleeves posted by stan on December 02, 2003 at 01:14:47:
Hello Stan, never did a 3 banger but have sleeved deveral 4 cyls. I found a big variation in the finish O.D of the perkins sleeves some go easy and some I have had to hone the block and still took 20+tons on the press. Hope the freezer thing works. Wonder if anyone else ever ran into the perkins problem of pistons being of different wrist pin to top length variations. Had them hit the valves and a canadian mech said they had to be installed-- measured then turned to height worked ever time after that. John (Or)
Follow Ups:
Home
| Forums
Today's Featured Article -
Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|