Posted by RGMartin on August 22, 2012 at 06:09:28 from (220.127.116.11):
I picked up a 92 chevy over the summer for a beater farm truck. I have been trying to sort out all its Gremlins to get it ready to haul some grain. Couple questions...
The 2 speed axle blows fuses any time you try to shift it. Is this likely just a wiring issue, or is there some inherent design flaw in the 2 speed which goes bad after 20 years?
Also the injected 366, I know on the Ford gassers in trucks you are supposed to "drive it like you stole it" in order to save the bottom end. Same issue with the Chevys? Anything to keep an eye on? it sounds good, starts good, seems to have OK power, but I'm sure that opinion will change once I put 250 bu of corn on it.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.