Posted by John T on October 04, 2013 at 17:56:37 from (67.78.33.134):
In Reply to: Sparkle question posted by Bfullmer on October 04, 2013 at 14:04:34:
I agree with my friend the Dusty man and the other sparkies. The motors what you call "power output" is the same if used at 120 versus 240 volts since P = E x I and when the voltage doubles the amps is halved. 120 volts x 10 amps = 1200 watts or 240 volts x 5 amps still = 1200 watts.
HOWEVER if I had my druthers, I'd run it at the higher voltage.
GENERALLY SPEAKING There are wasted I Squared R heat energy losses in resistive conductors (even copper wire has some resistance),,,,,,,,, anytime you can reduce voltage drop across a feeder line that's a also a good thing,,,,,,,,,,,,hey copper is expensive and anytime you can save on wire costs I'm all for it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.